全自动造型机故障检测之压头部分 The head part of automatic machine failure detection 全自动造型机在使用一段时间后，压头可有能出现摆动动作迟钝、缓慢、应按下列方法进行造型机保养。 The automatic molding machine is used for a period of time, the pressure head can have the ability to appear to be slow, slow, should press the following method to make the machine to maintain. 1、造型机故障检测时，检查造型机压头前后板间隙，是否有什么铁碴等异物阻碍，可清除后试车。 In the case of machine failure detection, check the front and rear panel of the molding machine, and if there are any obstacles such as iron, it can be cleared and then cleared. 2、打开压头上后面两根进气管，操纵阀分别扳在原位与摆入，看看管口进气是否够大，如果进气量小也会造成压头摆动缓慢，造型机故障检测时，若是此原因可一直检查到操纵阀，直致空气滤清气，是否堵塞。 2, open the pressure head behind two inlet pipe, control valve pull in in situ and put into the respectively, and see whether the nozzle inlet is enough big, if small air inflow also causes pressure head swinging slowly, molding machine fault detection, if the reason for this can always check to control valve, straight to the air filtration, blockage. 3、全自动造型机压头上面有盖板，打开观察齿条是否锈蚀严重，如果发生此造型机故障，同样会造成压头动作迟钝，可用煤油或汽油清洗即可。 3, automatic molding machine head with flat, open the observe whether rack is corroded seriously, in the event of the molding machine fault, also can cause head moves slow, can use kerosene or gasoline wash. 4、全自动造型机故障检测时，若上述情况都没发生，就应打开压头两侧法兰盘，检查齿条两侧Y型密封圈是否老化、变形，如是，也可造成压头缓慢。 4, automatic molding machine fault detection, if the situation doesn't happen, you should open the pressure head on both sides of the flange, check whether the rack on both sides of the y-shaped sealing ring is aging, deformation, so, also can cause pressure head slowly. 5、打开位于造型机压头后上端法兰盘，检查齿轮轴承的黄油是否变质，如果是这样，可用煤油或汽油冲洗，同时搬动压头，会感觉越来越松。 After 5, open in the molding machine head upper flange, check whether the gear bearing butter is bad, if so, can use kerosene or gasoline wash, lift head at the same time, will feel more and more loose.