全自动造型机故障检测之压头部分
The Pressure Head of Automatic Molding Machine Fault Detection
全自动造型机在使用一段时间后，压头可有能出现摆动动作迟钝、缓慢、应按下列方法进行造型机保养。
After using for a period of time, the indenter may swing slowly and slowly. Maintenance of the moulding machine should be carried out according to the following methods.
1、造型机故障检测时，检查造型机压头前后板间隙，是否有什么铁碴等异物阻碍，可清除后试车。
1. When inspecting the malfunction of the moulding machine, check the clearance between the front and back plates of the moulding machine press head, and whether there is any foreign material such as iron ballast, which can be removed after the test run.
2、打开压头上后面两根进气管，操纵阀分别扳在原位与摆入，看看管口进气是否够大，如果进气量小也会造成压头摆动缓慢，造型机故障检测时，若是此原因可一直检查到操纵阀，直致空气滤清气，是否堵塞。
2. Open the two intake pipes on the back of the pressure head, and pull the control valve in situ and put in separately, to see if the intake is large enough. If the intake is small, the pressure head will swing slowly. When the molding machine fails to detect, if this reason can be inspected all the way to the control valve, the air will be filtered and blocked.