造型机使用时，操作者应熟悉造型机的机械部件、电器部件、动作程序、润滑系统等情况，以及设备使用中规定的其它要求。 1, when modeling machine is used, operators should be familiar with the mechanical parts, electrical components, action procedures, lubrication systems and other requirements specified in the equipment. 造型机紧实砂型程序4个步骤：振实、压头摆入、压实、压头摆出 4 steps of molding machine compacting sand mold program: vibrating, pressing head, compacting, pressing head out 造型机起模程序：工作台夹紧、起模杆升起、运走砂箱、机箱部复位 Molding machine lifting program: working table clamping, lifting rod lifting, transporting sand box, reset of chassis part 2、造型机使用时，开动设备前，应先检查造型机的润滑装置是否完善，并按规定加油，检查各紧部件是否紧固，各操作手柄是否处于零位（空位），气阀动作是否灵活，管路有无漏气，然后打开总气阀放掉管路中的积气和积水。 2 molding machine when used to actuate the device before, should check the molding machine lubrication device is perfect, and according to the provisions of the gas, check the tension member is fastened, the operating handle is zero (vacancy), valve action is flexible, pipeline without leakage, and then open the total valve drain and gas accumulation the water in the pipeline. 3、严禁开空车，必须在有载荷的情况下进行试车，检查各工作状态是否正常，对应该加油的地方进行加油润滑。试车正常后方可进行工作。 3. It is forbidden to open the empty car. It is necessary to test the car under the condition of load, check whether the working condition is normal, and lubricate the refueling place. The test car can work in the normal rear. 4、造型机使用时要认真观察运转情况，在操作中应经常用空气吹净润滑部位和运转部位的砂粒，严禁各润滑部位粘砂。 4, when using the molding machine, we must carefully observe the running situation. In operation, we should often blow the net parts of the lubrication parts and the running parts with air, and strictly prohibit the sand sticking of the lubricating parts. 5、造型机使用时，开闭手柄气阀时动作要平稳。 5, when the molding machine is used, the operation should be smooth when the handle valve is opened and closed. 6、每完成一次造型工作后要将工作台清理干净，才能进行第二次造型工作的开始。 6, after each completion of the modeling work to clean up the workbench, to carry out the start of the second modeling work