| 造型机安全操作的要点介绍 |
| 添加时间：2017/8/29 16:01:17 浏览次数： |
| 1、造型机使用时，操作者应熟悉造型机的机械部件、电器部件、动作程序、润滑系统等情况，以及设备使用中规定的其它要求。 1 when molding machine is used, the operator should be familiar with molding machine's mechanical parts, electrical components, action procedures, lubrication system, etc., and other requirements stipulated in the equipment use. 造型机紧实砂型程序4个步骤：振实、压头摆入、压实、压头摆出 Molding machine compaction sand procedures, 4 steps: vibration, press head, pendulum, compaction, pressure head out 造型机起模程序：工作台夹紧、起模杆升起、运走砂箱、机箱部复位 Molding machine starting process: work platform clamping, lifting the rod, removing sand box, chassis reset 2、造型机使用时，开动设备前，应先检查造型机的润滑装置是否完善，并按规定加油，检查各紧部件是否紧固，各操作手柄是否处于零位（空位），气阀动作是否灵活，管路有无漏气，然后打开总气阀放掉管路中的积气和积水。 2 molding machine when used to actuate the device before, should check the molding machine lubrication device is perfect, and according to the provisions of the gas, check the tension member is fastened, the operating handle is zero (vacancy), valve action is flexible, pipeline without leakage, and then open the total valve drain and gas accumulation the water in the pipeline. 3、严禁开空车，必须在有载荷的情况下进行试车，检查各工作状态是否正常，对应该加油的地方进行加油润滑。试车正常后方可进行工作。 3, strictly prohibit driving empty cars, must be in the case of load test, check the work status is normal, should refuel place lubrication. The test run is normal before operation. 4、造型机使用时要认真观察运转情况，在操作中应经常用空气吹净润滑部位和运转部位的砂粒，严禁各润滑部位粘砂。 4, molding machine use, we should seriously observe the operation, in the operation should always use air to blow lubrication parts and parts of the sand, it is prohibited to lubricate parts of sand. 5、造型机使用时，开闭手柄气阀时动作要平稳。 5, molding machine use, open and close the handle valve movement should be smooth. |
| 上一页 造型机故障检测的方法 |
| 下一页 造型机有什么用 |
Copyright © 技术支持：遨游网络